Scranton Floor Staining Tips and Techniques

You can give new life and a lovely appearance to scranton hardwood floors. The process of scranton floors staining isn’t as complicated as you may think. By following these tips and techniques, you can get results that you are very happy with!

Prepare the Floors

Before you move into the actual scranton floor staining part of the process, you need to prepare the floors. You want to carefully examine them. Make sure that they are free from scratches or other defects. It can be worth it to spend some time buffing or sanding in order to eliminate the identified defects.

If there are areas that show nail holes or cracks, use putty or filler to make them look smooth. If you will be sanding, make sure that you go the direction of the grain of the wood. Use 30 or 60 grit sandpaper. Clean the areas you sand with mineral spirits.

Base Coat

In order to really get the wonderful results you seek through floor staining, take the time to apply a base coat. You can use water or oil based but it is recommended to go with a water based product. It will take two coats, and you should allow three hours between applications.

Select the Floor Staining Color

Take your time to look at samples of scranton floor staining colors before you buy anything. They range from very light to very dark colors. They will often dry lighter than they are applied. If you aren’t sure, get a small can and apply it to a hidden area of your hardwood flooring. Allow it to completely dry and make sure you like it.

A light color can allow blemishes to be easier to see. However, darker colors can allow dust and debris to be easily seen. With darker colors, you need to make sure you have very good lighting so that you don’t cast shadows around the room. For most people though, the scranton floor staining color comes down to their personal preference.

Always apply at least two coats of the floor staining product. Make sure you follow the directions on the product label. Try to keep windows closed so that dust isn’t coming in while the stain is still wet. You may have to use other forms of ventilation to ensure the fumes don’t get too strong as you work with the product.

Top Coat

Once you are happy with the color depth of the floor staining, you need to allow it to completely dry. Then you can add two coats of the top coat. This should be a water-based polyurethane product. Avoid those that are oil-based as they will require additional coats to get the same results.

Quality Brushes

When it comes to floor staining, don’t cut corners with brushes that aren’t good quality. Instead, you need to make sure that they are well made with bristles that aren’t going to break off and be found later stuck onto your hardwood floors. Long strokes that are consistent is going to really enhance the end results you get.